Drill Press Upgrade - Part 6 Assembly of cubby and carcass

The assembly of the cubbies and carcase is very simple. There is no glue used on this and they are simply held together with wood screws. Clearance holes are drilled into the rear panel of the carcass, the cubby is aligned with the edge of the carcass and clamped into place.
Care is taken to ensure the sliding door slots in the bottom plates are aligned and then they are screwed together.

The same process is carried out on the other side.

If you got your measurements right then the column of the drill press will clear the gap created by the back faces of each cubby.